Elevator monitoring bridge installation needs to avoid these pits

The elevator is a complex closed environment, and the mature radio monitoring has become the first choice for elevator monitoring applications. The wireless bridge is a transmission device in wireless monitoring, which is convenient to install and low in cost. However, in the actual elevator monitoring and installation process, there will be many problems, here are a few points, I hope to help everyone in the actual installation.

Pit 1: Blind entry?

The elevator belongs to special equipment and has certain dangers. Do not enter the scene blindly.

1. Before installation, we need to go to the property to understand the wiring of on-site elevators, monitoring, etc.

2. First contact the elevator maintenance personnel, the external personnel must be led by the elevator maintenance personnel to enter the field (the elevator operators are required to hold the special operation operation certificate issued by the State Administration of Work Safety to be employed).

Pit 2: How to solve the power supply of the bridge?

The elevator brands are different and the structure is different. The configuration of the top and bottom of the car is different. The power supply of the elevator car roof of the renovation project is very likely to be occupied by the camera. Where does the bridge take power? During the survey, pay attention to whether the top of the car is a plug. If there is no plug, you need to install a plug to facilitate power.

Pit 3: Where is the bridge installed?

Select the bridge installation point to avoid avoiding obstructions, especially metal substances will affect the signal. The bridge at the top of the elevator car can be installed on the top railing; the other one is installed in the foundation pit? It is possible that the foundation pit will accumulate water and affect the bridge signal transmission, so it is the most ideal method to fix it on the wall of the elevator shaft.

Pit 4: What is the bridge fixed?

How to fix the bridge at the top or bottom of the elevator shaft? When the bridge is shipped from the factory, most of the manufacturer's accessories only contain hoops or straps. There is no bracket, so don't forget to buy brackets! Hold the bridge and tie the bridge tightly.

Pit 5: How to set up the bridge?

Most bridge configuration methods on the market:

1. WEB interface configuration: first enter the two bridge WEB interface to set the IP address, then set the transmitter, receiver, and finally set the channel.

2. Dial-up bridge: The dial-up button on the bridge, some represent the working mode code, packet pairing code, IP address code, this must be carried out with the instructions to study well to complete the pairing well.

3. Digital Bridge: Visually present the set information on the bridge, but it still needs to manually set the IP address and channel on the bridge, and then press the bridge's dial button to make it pair successfully.

As an important wireless monitoring transmission equipment, the wireless bridge is related to the performance and correct use of the entire wireless monitoring system. Therefore, users should know more about wireless bridge knowledge and choose reliable brand products.